Removal
NOTE:
LH (left-hand) side shown, RH (right-hand) side similar.
Remove the rear door window regulator and motor.
Refer to: Rear Door Window Regulator and Motor (501-11 Glass, Frames and Mechanisms, Removal and Installation)...
Other information:
Starting System
The starting system controls the cranking of the engine. When the
PCM
receives inputs from the ignition switch, transmission (with automatic
transmission) or clutch pedal position switch (with manual
transmission), run/start relay and the BCM it then energizes the BJB
starter relay...
Special Tool(s) /
General Equipment
Hose Clamp Remover/Installer
Removal
Drain the cooling system.
Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding (303-03C Engine Cooling, General Procedures).
Disconnect the electrical connector...