Ford Escape: Engine System - General Information / General Procedures - Piston Diameter

General Procedures - Oil Pressure Test - 2.5L Duratec – Hybrid (121kW/164PS) (BG)

Disconnect the high voltage connector.For additional information, refer to: High Voltage Connector Disconnect and Connect (414-03A High Voltage Battery, Mounting and Cables, General Procedures)...

General Procedures - Piston Inspection

Inspection NOTE: Do not use a caustic cleaning solution or a wire brush to clean the pistons or damage can occur. Clean and inspect the (1) ring lands, (2) pin bosses, (3) skirts and the (4) tops of the pistons...

Other information:

Ford Escape 2020-2026 Service Manual: Removal and Installation - Axle Assembly

Special Tool(s) / General Equipment Transmission Jack Wooden Block Removal NOTE: Removal steps in this procedure may contain installation instructions. Remove the rear halfshafts. Refer to: Rear Halfshaft (205-05 Rear Drive Halfshafts, Removal and Installation)...

Ford Escape 2020-2026 Service Manual: Removal and Installation - Fuel Vapor Vent Valve - Plug-In Hybrid Electric Vehicle (PHEV)

Removal   WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly flammable mixtures may be present and may be ignited. Failure to follow these instructions may result in serious personal injury...