Ford Escape 2020-2026 Service Manual / Body and Paint / Body and Paint / Body Closures / General Procedures - Power Liftgate Initialization

Ford Escape: Body Closures / General Procedures - Power Liftgate Initialization

Programming

NOTE: This procedure clears and then sets new open and close end points in the RGTM memory.

Turn the ignition ON.

Using a scan tool perform the RGTM self test to complete power liftgate initialization. From the diagnostic scan tool, enter TOOLBOX > Self Test > RGTM > Run Selected Procedure.

General Procedures - Liftgate Alignment

Special Tool(s) / General Equipment Interior Trim Remover Inspection NOTE: Removal steps in this procedure may contain installation details...

General Procedures - Rear Door Alignment

Inspection NOTE: Removal steps in this procedure may contain installation details. NOTE: LH side shown, RH side similar. Inspect the body-to-rear door dimensions...

Other information:

Ford Escape 2020-2026 Service Manual: Removal and Installation - Audio Front Control Module (ACM)

Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: If installing a new module, it is necessary to upload the module configuration information to the scan tool prior to removing the module...

Ford Escape 2020-2026 Service Manual: Removal and Installation - Front Door Skin Panel

Special Tool(s) / General Equipment Scraper for Straight Edges Grinder Hot Air Gun Knife MIG/MAG Welding Equipment Locking Pliers Materials Name Specification Metal Bonding AdhesiveTA-1, TA-1-B, 3M™ 08115, LORD Fusor® 108B, Henkel Teroson EP 5055 - Seam SealerTA-2-B, 3M™ 08308, LORD Fusor® 803DTM - Flexible Foam Repair3M�..

Push Button Ignition Switch

Ford Escape. Push Button Ignition Switch

Switching the Ignition Off

When the ignition is on or in accessory mode, press the push button ignition switch once without your foot on the brake pedal.