Ford Escape: Handles, Locks, Latches and Entry Systems / General Procedures - Staged Unlock Programming
Activation
-
With the ignition in OFF, press the LOCK and UNLOCK buttons on the RKE transmitter simultaneously for 4 seconds.
-
The turn signals flash twice to indicate the mode change.
-
Repeat these steps to enable/disable the staged unlocking feature.
Special Tool(s) /
General Equipment
Flat-Bladed Screwdriver
Interior Trim Remover
Activation
Remove the liftgate latch access cover from the center of the liftgate trim panel...
Removal
NOTE:
LH (left-hand) side shown, RH (right-hand) side similar.
NOTE:
Repair individual door lock cylinders by discarding the
inoperative door lock cylinder and building a new door lock cylinder
using the appropriate lock repair service kit...
Other information:
Removal
Remove the glove compartment.
Refer to: Glove Compartment (501-12 Instrument Panel and Console, Removal and Installation).
Remove the screws and the air distribution door actuator.
Disconnect the electrrical connector...
Initialization
WARNING:
Before beginning any service procedure in this
section, refer to Safety Warnings in section 100-00 General Information.
Failure to follow this instruction may result in serious personal
injury.
Refer to: Health and Safety Precautions (100-00 General Information, Description and Operation)...