Ford Escape: Wipers and Washers / General Procedures - Washer Hose Repair
Repair
NOTE:
This procedure may be carried out on rubber hoses only. If a
plastic washer hose is damaged, a new washer hose must be installed.
-
Locate and verify the damaged washer hose.
-
Cut the hose cleanly and remove the damaged portion of the washer hose.
Dimension:
0.5000
in (
12.7
mm)
-
Install a windshield washer hose adapter between the cut ends of the hose.
-
NOTE:
In difficult cases, clamping may be required.
If necessary, install a segment of 6.4 mm (0.25 in) ID
black rubber hose over the ends of the washer hose and clamp both ends
of the rubber hose using spring clamps.
Disconnect
WARNING:
Before beginning any service procedure in this
section, refer to Safety Warnings in section 100-00 General Information...
Materials
Name
Specification
Motorcraft® Ultra-Clear Spray Glass CleanerZC-23
ESR-M14P5-A
Removal
Remove the interior rear view mirror...
Other information:
System Operation
System Diagram
Item
Description
1
GWM
2
RH steering wheel switch
3
PSCM
4
BCM
5
Door/liftgate ajar switches
6
SODR
7
Fuel pump and sender unit
8
IPC
9
APIM
10
Washer fluid level switch
11
Message center display
12
PCM
13
Engine oil pressure sensor..
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Module
DTC
Description
Action
BCM
B10AB:00
Remote Keyless Entry Synchronization: No Sub Type Information
GO to Pinpoint Test O
BCM
B10C7:01
Int..