Ford Escape: Anti-Lock Brake System (ABS) and Stability Control / Removal and Installation - Anti-Lock Brake System (ABS) Module - Vehicles With: Vacuum Brake Booster

Removal

NOTE: A new HCU is equipped with an ABS module. A new ABS module does not come equipped with an HCU .

NOTE: Removal steps in this procedure may contain installation details.

1. Remove the HCU .
   Refer to: Hydraulic Control Unit (HCU) - Vehicles With: Vacuum Brake Booster (206-09 Anti-Lock Brake System (ABS) and Stability Control, Removal and Installation).
   

1. NOTICE: Make sure the HCU and ABS module are clean and free of brake fluid or foreign material before separating the components. Do not allow any brake fluid or foreign material to enter the mating side of the ABS module or component damage can occur.

   Remove the bolts and the ABS module. Discard the bolts.
   Torque: 49 lb.in (5.5 Nm)

Installation

1. To install, reverse the removal procedure.