Ford Escape: Exterior Lighting / Removal and Installation - Hazard Flasher Switch
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the center registers.
Refer to: Center Registers (412-00 Climate Control System - General Information, Removal and Installation).
-
Release the tabs and remove the hazard flasher switch from the center registers.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the front turn signal lamp bulb cover.
Rotate the front turn signal lamp bulb holder
counterclockwise and remove the turn signal bulb holder from the
headlamp assembly...
Special Tool(s) /
General Equipment
Ford Diagnostic Equipment
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
To prevent setting DTC make sure the ignition is in the OFF position
prior to disconnecting the accelerator pedal electrical connector.
Disconnect the electrical connector, remove the nuts and the accelerator pedal assembly...
Plastic Components
The
following illustration(s) are not all-inclusive of trim levels
available. The actual trim level of the vehicle will determine the
viability of carrying out a plastics repair. Typically components with
moulded-in color or a textured finish are not considered repairable
components...