Ford Escape Manuals
Ford Escape 2020-2026 Service Manual / Chassis / Suspension / Front Suspension / Removal and Installation - Wheel Studs

Ford Escape: Front Suspension / Removal and Installation - Wheel Studs

Removal

  1. NOTE: Wheel studs are not serviceable separately. Wheel bearing and wheel hub assembly must be replaced.

    Remove the front wheel bearing and wheel hub.
    Refer to: Front Wheel Bearing and Wheel Hub (204-01 Front Suspension, Removal and Installation).

Installation

  1. NOTE: Wheel studs are not serviceable separately. Wheel bearing and wheel hub assembly must be replaced.

    Install the front wheel bearing and wheel hub.
    Refer to: Front Wheel Bearing and Wheel Hub (204-01 Front Suspension, Removal and Installation).

    Removal and Installation - Wheel Knuckle

    Special Tool(s) / General Equipment 204-161 (T97P-1175-A) Installer, HalfshaftTKIT-1997-LM2TKIT-1997-F/FM2TKIT-1997-FLM2 205-D070 (D93P-1175-B) Remover, Front Wheel Hub Tie Rod End Remover Removal NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems...

    Disassembly and Assembly - Front Strut and Spring Assembly

    Special Tool(s) / General Equipment Spring Compressor Vise DISASSEMBLY NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems...

    Other information:

    Ford Escape 2020-2026 Service Manual: Description and Operation - Roof Opening Panel - System Operation and Component Description


    System Operation Item Description 1 BCM 2 Roof Opening Panel Control Switch 3 Sliding Glass Motor / Module 4 Shade Motor Roof Opening Panel Operating System The accessory delay relay in the BCM supplies voltage through fuse F6 (10A) to the sliding glass motor / module allowing the motors to respond to roof opening panel control sw..

    Ford Escape 2020-2026 Service Manual: Removal and Installation - Cooling Module


    Special Tool(s) / General Equipment Hose Clamp Remover/Installer Interior Trim Remover Removal NOTICE: When removing any turbocharger air intake system components, make sure to cover any open ports to prevent debris from entering the system. The turbocharger compressor vanes can be damaged by even the smallest particles. All components need to be inspected and cleaned prior..

    Categories

    Fastening the Seatbelts

    Ford Escape. Fastening the Seatbelts

    Insert the belt tongue into the proper buckle, the buckle closest to the direction the tongue is coming from, until it engages.

    read more

    Copyright © 2026 www.fordescape4.com