Ford Escape 2020-2026 Service Manual / Electrical / Battery and Charging System / Generator and Regulator / Specifications

Ford Escape: Generator and Regulator / Specifications

General Specifications

Item	Specification
1.5L EcoBoost Vehicles
Rating	180 amps
Generator amps at 80.6°F (27°C)	70 amps at 750 rpm (min) to 172 amps at 2,500 rpm (max)
Generator pulley ratio	2.59
Generator pulley replaceable	Yes
Generator pulley type	Overrunning Alternator Decoupler (OAD)
Voltage regulator type	Electronic internal with generator
2.0L EcoBoost Vehicles without AC Power Outlet
Rating	150 amps
Generator amps at 80.6°F (27°C)	85 amps at 650 rpm (min) to 155 amps at 2,200 rpm (max)
Generator pulley ratio	2.76
Generator pulley replaceable	Yes
Generator pulley type	Overrunning Alternator Decoupler (OAD)
Voltage regulator type	Electronic internal with generator
2.0L EcoBoost Vehicles with AC Power Outlet
Rating	190 amps
Generator amps at 80.6°F (27°C)	105 amps at 650 rpm (min) to 200 amps at 2,200 rpm (max)
Generator pulley ratio	2.76
Generator pulley replaceable	Yes
Generator pulley type	Overrunning Alternator Decoupler (OAD)
Voltage regulator type	Electronic internal with generator

Generator and Regulator

Removal and Installation - Generator - 1.5L EcoBoost (132kW/180PS) – I3 (Y1), Vehicles Built From: 2-October-2020

Removal NOTE: Removal steps in this procedure may contain installation details. Disconnect the battery. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures)...

Other information:

Ford Escape 2020-2026 Service Manual: Removal and Installation - Charge Status Indicator (CSI) - Plug-In Hybrid Electric Vehicle (PHEV)

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the LH fender splash shield. Refer to: Fender Splash Shield (501-02 Front End Body Panels). Disconnect the CSI electrical connector, detach the retainer and position the wire harness aside...

Ford Escape 2020-2026 Service Manual: Removal and Installation - Rear Lamp Assembly

Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: Left hand side shown, right hand similar. Liftgate mounted rear lamp assemblies Remove the liftgate trim panel...

Master Access Code

What Is the Master Access Code

The master access code is a factory-set five-digit entry code. You can operate the keypad with the master access code at any time. The master access code is on the owner’s wallet card in the glove box and is available from an authorized dealer.

Displaying the Master Access Code

To display the factory-set code in the information display:

Ford Escape. Master Access Code

Remove the rubber mat. Insert the first programmed key in the backup slot. Press the push button ignition switch once and wait a few seconds. Press the push button ignition switch again and remove the key. Within 10 seconds, place a second programmed intelligent access key in the backup slot and press the push button ignition switch.