Ford Escape: Fuel System - General Information / Acceleration Control

Removal and Installation - Fuel Tank Filler Pipe

Removal NOTE: Removal steps in this procedure may contain installation steps. Refer to: Gasoline and Gasoline-Ethanol Fuel Systems Health and Safety Precautions (100-00 General Information, Description and Operation)...

Description and Operation - Acceleration Control - Overview

The acceleration controls consist of the accelerator pedal, APP sensor and bracket assembly. The engine management system electronically operates the throttle of the engine in response to throttle pedal movements initiated by the driver...

Other information:

Ford Escape 2020-2026 Service Manual: General Procedures - Oil Pressure Test - 2.5L Duratec – Hybrid (121kW/164PS) (BG)

Disconnect the high voltage connector.For additional information, refer to: High Voltage Connector Disconnect and Connect (414-03A High Voltage Battery, Mounting and Cables, General Procedures). NOTE: It is necessary to disconnect the battery to avoid setting any DTCs that could cause the PCM to command the oil pressure to other than what should be observed from a correctly ..

Ford Escape 2020-2026 Service Manual: Removal and Installation - Loadspace Trim Panel

Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: LH (left hand) shown, RH (right hand) similar. Remove the rear scuff plate trim panel. Refer to: Rear Scuff Plate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation). Remove the loadspace scuff plate trim panel. Refer to: Loadspace Scuff Plate Trim Panel (50..