Ford Escape: Climate Control System - General Information / Removal and Installation - Evaporator Temperature Sensor
Removal
NOTE:
The evaporator temperature sensor is available only as part of the evaporator.
-
Remove the evaporator.
Refer to: Evaporator (412-00 Climate Control System - General Information, Removal and Installation).
Installation
-
Transfer the components from the old housing to the new housing as needed.
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the heater core.
Refer to: Heater Core (412-00 Climate Control System - General Information, Removal and Installation)...
Removal
Remove the climate control housing.
Refer to: Climate Control Housing (412-00 Climate Control System - General Information, Removal and Installation)...
Other information:
Removal
NOTICE:
Under no circumstances should the accessory drive belt,
tensioner or pulleys be lubricated as potential damage to the belt
material and tensioner damping mechanism will occur. Do not apply any
fluids or belt dressing to the accessory drive belt or pulleys...
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
WARNING:
The following procedure describes critical repair steps
required for correct seat component installation. Follow all notes and
steps carefully. Do not place any objects between the seat components
and the body of the vehicle, nor any objects within a joint internal to
the seat structure...