Ford Escape Manuals

Ford Escape: Automatic Transmission - Automatic Transmission – HF45 / Removal and Installation - Inverter System Controller

Removal

  1. To remove the ISC (inverter system controller).
    Refer to: Inverter System Controller [SOBDMC] (303-14D Electric Powertrain Control, Removal and Installation).

Installation

  1. To install, reverse the removal procedure.

    Removal and Installation - Halfshaft Seal RH - FWD

    Special Tool(s) / General Equipment 205-153 (T80T-4000-W) Handle 307-758Installer, Axle Seal -FWD Flat Headed Screw Driver Removal With the vehicle in NEUTRAL, position it on a hoist...

    Removal and Installation - Roll Restrictor RH

    Special Tool(s) / General Equipment Wooden Block Removal With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation)...

    Other information:

    Ford Escape 2020-2026 Service Manual: General Procedures - Climate Control Tools and Equipment


    Climate Control Tools and Equipment Use the correct adapters with the Rotunda approved A/C Tools. NOTE: The climate control tools and equipment listed are regionally required for Ford North America A/C service repairs. Make sure to use regionally approved A/C tools and equipment that are based on regional and/or environmental requirements...

    Ford Escape 2020-2026 Service Manual: Removal and Installation - Front Bumper


    Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: Removal steps in this procedure may contain installation details. Remove the front bumper cover. Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation)...

    Categories

    Vehicle Identification

    Locating the Vehicle Identification Number

    The vehicle identification number is on the left-hand side of the instrument panel.

    Ford Escape. Vehicle Identification

    read more

    Copyright © 2026 www.fordescape4.com