Ford Escape: Interior Trim and Ornamentation / Removal and Installation - Rear Scuff Plate Trim Panel
Special Tool(s) /
General Equipment
Removal
NOTE:
LH (left hand) shown, RH (right hand) similar.
-
Release the clips and remove the rear scuff plate trim panel.
Use the General Equipment: Interior Trim Remover
Installation
-
To install, reverse the removal procedure.
-
Inspect and position the rear door weather strip lip so that it overlaps the rear scuff plate trim panel.
Special Tool(s) /
General Equipment
Pick Hook
Interior Trim Remover
Removal
NOTE:
LH (left hand) shown, RH (right hand) similar.
NOTE:
Removal steps in this procedure may contain installation details...
Special Tool(s) /
General Equipment
Flat Headed Screw Driver
Interior Trim Remover
Removal
Fully extend and lower the steering column...
Other information:
Removal
NOTE:
LH (left-hand) side shown, RH (right-hand) side similar.
NOTE:
Removal steps in this procedure may contain installation details.
Remove the exterior rear door handle access plug.
Remove the exterior rear door handle...
Special Tool(s) /
General Equipment
205-199
(T83T-3132-A1)
Installer, Spindle/Axle ShaftT83-4000-ATKIT-1983-FTKIT-1983-FLMTKIT-1983-FX
308-777Remover and Installer, PTU Input Shaft Seal
308-969Installer, Pinion Seal
Slide Hammer Dent Puller
Plastic Mallet
Two Leg Puller
Removal
Remove the PTU...