Ford Escape: Automatic Transmission - Automatic Transmission – HF45 / Removal - Transmission
NOTE:
The transmission cannot be removed from the vehicle separate
from the engine. Separate the transmission from the engine following the
additional steps in the transmission procedure.
-
Remove the transmission.
Refer to: Transmission (307-01B Automatic Transmission - Automatic Transmission – HF45, Removal and Installation).
Special Tool(s) /
General Equipment
Trolley Jack
Wooden Block
Removal
Drain the Electric Powertrain Cooling System.
Refer to: Cooling System Filling and Bleeding (303-03D Electric
Powertrain Cooling - Hybrid Electric Vehicle (HEV), General Procedures)...
Special Tool(s) /
General Equipment
307-163
(T86P-70043-A)
Remover, Stator Case BearingTKIT-1986-LMTKIT-1986-F
307-586Differential bearing cup removerTKIT-2006UF-FLMTKIT-2006UF-ROW
307-741Spring Compressor, F Clutch
307-821Motor Rotor Remover Installer
308-001
(T58L-101-B)
Remover, Pilot Bearing
Hydraulic Press
Puller
Punch
Wooden Block
..
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
The EBB and the ABS module are serviced as an assembly and should not be separated.
NOTE:
The PMI process must begin with the current ABS module installed. If
the current ABS module does not respond to the diagnostic scan tool, the
tool may prompt for As-Built Data as part of the repair.
..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the roof opening panel glass.
Refer to: Roof Opening Panel Glass (501-17 Roof Opening Panel, Removal and Installation).
Press the glass down button and then press the shield
close button closing the roof opening panel shield until the cross bar
of the shield is positioned in the mi..