Ford Escape 2020-2025 Service Manual / Chassis / Brake System / Brake System - General Information / Specifications

Ford Escape: Brake System - General Information / Specifications

Lubricants, Fluids, Sealers and Adhesives

	Specifications
DOT 4 LV brake fluid	Material: Motorcraft® DOT 4 LV High Performance Motor Vehicle Brake Fluid / PM-20 (WSS-M6C65-A2)

Torque Specifications

Item	Nm	lb-ft	lb-in
Front caliper bleeder screw	15	-	133
Rear caliper bleeder screw	15	-	133
Master cylinder brake tube fittings	18	-	160

General Specifications

Item	Specification
Front brake disc minimum thickness	0.984 in ( 25 mm)
Rear brake disc minimum thickness	0.354 in ( 9 mm)
Brake pad minimum thickness	0.079 in ( 2 mm)
Brake pad maximum taper wear (in any direction)	0.118 in ( 3 mm)

Brake System - General Information

Diagnosis and Testing - Brake System

Global Customer Symptom Code (GCSC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices...

Other information:

Ford Escape 2020-2025 Service Manual: Removal and Installation - Antenna Isolator Module

Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: LH isolator is shown, RH isolator is similar. Release the clips, the trim anchors and remove the center upper liftgate interior trim panel...

Ford Escape 2020-2025 Owners Manual: Adjusting the Headlamps

Vertical Aim Adjustment The headlamps on your vehicle are properly aimed at the assembly plant. If your vehicle has been in an accident, the alignment of your headlamps should be checked by your authorized dealer. 8 feet (2.4 meters) Center height of lamp to ground 25 feet (7...

Vehicle Identification

Locating the Vehicle Identification Number

The vehicle identification number is on the left-hand side of the instrument panel.

Ford Escape. Vehicle Identification