Ford Escape 2020-2026 Owners Manual / Pre-Collision Assist

Ford Escape: Pre-Collision Assist

What Is Pre-Collision Assist

Pre-collision assist detects and warns of approaching hazards in the roadway. If your vehicle is rapidly approaching another stationary vehicle, a vehicle traveling in the same direction as yours, or a pedestrian within your driving path, the system provides multiple levels of assistance to help avoid a collision.

Cross Traffic Alert – Troubleshooting

C..

How Does Pre-Collision Assist Work.

The system warns the driver of potential hazards by providing three levels of assistance. If your vehicle is rapidly approaching potential hazards the system provides the following levels of functionality: Alert...

Other information:

Ford Escape 2020-2026 Service Manual: General Procedures - Ride Height Measurement

Special Tool(s) / General Equipment Surface Gauge Check NOTE: Make sure that the vehicle is positioned on a flat, level surface and the tires are inflated to the correct pressure. Vehicle should have a full tank of fuel. Before measuring ride height check: Tires are inflated to the correct pressure...

Ford Escape 2020-2026 Service Manual: General Procedures - Locked Seatbelt Retractor Releasing

Repair NOTE: If the seatbelt webbing does not extract from the seatbelt retractor from the stowed position, this may be due to a normal condition which happens when the seatbelt retracts at a high rate of speed. Follow these steps to release the seatbelt...

Master Access Code

What Is the Master Access Code

The master access code is a factory-set five-digit entry code. You can operate the keypad with the master access code at any time. The master access code is on the owner’s wallet card in the glove box and is available from an authorized dealer.

Displaying the Master Access Code

To display the factory-set code in the information display:

Ford Escape. Master Access Code

Remove the rubber mat. Insert the first programmed key in the backup slot. Press the push button ignition switch once and wait a few seconds. Press the push button ignition switch again and remove the key. Within 10 seconds, place a second programmed intelligent access key in the backup slot and press the push button ignition switch.