Ford Escape: Climate Control System - General Information / Removal and Installation - Sunload Sensor
Special Tool(s) /
General Equipment
Removal
-
Remove the sunload sensor
-
Disconnect the electrical connector.
Use the General Equipment: Interior Trim Remover
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Open the glove compartment and remove the check strap.
Fully lower the glove compartment...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Open the glove compartment and remove the check strap.
Fully lower the glove compartment...
Other information:
Overview
The DATC system maintains the selected vehicle interior temperature
by heating and/or cooling the air depending on the HVAC control panel
selection.
During A/C operation, the system reduces the relative humidity of the air inside the vehicle...
Removal
NOTE:
This step is only necessary when installing a new component.
NOTE:
The PMI (programmable module installation) process
must begin with the current DSM (driver front seat module) installed. If
the current DSM (driver front seat module) does not respond to the
diagnostic scan tool, the tool may prompt for As-Built Data as part of
the repair...