Ford Escape: Engine / Engine Cooling

Installation - Engine

S..

Specifications

  Lubricants, Fluids, Sealants and Adhesives   Material: Motorcraft® Yellow Concentrated Antifreeze/Coolant / VC-13-G (WSS-M97B57-A1)   Material: Motorcraft® Yellow Prediluted Antifreeze/Coolant / VC-13DL-G (WSS-M97B57-A2)   Material: Motorcraft® Premium Cooling System Flush / VC-1 (ESR-M14P7-A)  ..

Other information:

Ford Escape 2020-2026 Service Manual: Removal and Installation - B-Pillar Trim Panel

Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: LH (left hand) shown, RH (right hand) similar. Upper and lower B-pillar trim panels Remove the front scuff plate trim panel. Refer to: Front Scuff Plate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation). Remove the rear scuff plate trim panel. Refer to:..

Ford Escape 2020-2026 Service Manual: General Procedures - Intake Manifold Vacuum Test

Bring the engine to normal operating temperature. Connect the Vacuum/Pressure Tester to the intake manifold. Run the engine at the specified idle speed. The vacuum gauge should read between 51-74 kPa (15-22 in-Hg) depending upon the engine condition and the altitude at which the test is conducted. Subtract 4.0193 kPa (1 in-Hg) from the specified reading for every 304.8 m (1,00..